Cross Bar holder

Cross Bar holder

A 12mm/16mm OD round rod or tube can be held in the standoff cross bar holder, which is constructed of stainless steel with a brushed (satin) surface. Our cross bar holder is certain to fulfill your demands, regardless of whether you're searching for a practical substitute for a glass balustrade or simply want to add a little elegance to your home.

The Standard Specification of Cross Bar holder

The features of Cross Bar holder

The use of cross bar balustrade infill makes a bold statement and offers security.

Made from premium stainless steel, which has been flawlessly satin-finished.

Made to fit a stainless steel bar that is 12mm or 16mm in diameter.

With a through hole for use as an end piece, this tube fixing cross bar holder is used.

Produced in either 316 or 304 grade stainless steel (for the outside).

Options are available to suit tubes with a diameter of 42.4mm, 38.1mm, or 50.8mm.

Finished with a satin 320 grit brushed finish.

With the use of a drill, countersunk hex head screw, and hex head key, installation is straightforward.

The installation of Cross Bar holder

Cross Bar Guidelines 1

On the post, indicate where the hole is. This can be made easier using a little piece of masking tape. Create a hole with a 5 mm diameter.

Cross Bar Guidelines 2

Use a tap to make the 5mm hole.

Cross Bar Guidelines 3

A countersunk screw is used to secure the cross bar holder to the post.

Cross Bar Guidelines 4

Use a hex head key to tighten.

Cross Bar Guidelines 5

Place the rod into the holder for the crossbar.

Cross Bar Guidelines 6

Use a hex head key to secure with a grub screw.